here is the back of the shirt where the xbee lilypad arduino and power supply will be. green are the LCD’s. red is the power, and black is the ground.
this would be the sleeve. the circles are the LED’s with the RGB values on the bottom. I realize the sketch is a little crazy as I did it sort of “backwards” but I understand my mess. Essentially I believe that you can wire each value (so red, blue, and green) with the same wire respectively throughout the course of the 6 LED’s. So one thread would go through all the “R’s”, another through all the “B’s” so on and so fourth. Leaving about 4 digital pins needed on the Lilypad Arduino deck.